Specialty Engravers Fonts Selection
/i/Font Images/tester4.gif

Pantograph Patterns    Engraving Templates    Ornamentals

  • Easiest material for tracing. It's better than brass!
  • Cost Savings. We manufacture each font at our facility. No middleman! Rock bottom pricing.
  • Works on most all engravers.
  • Made in America. 
    Highest Quality.
  • Font Compositions. Each SE FONT set has all the necessary punctuation marks, numbers and associated characters. See the font assortment details listed below.
  • Font Tray for convenience included with each set. 
  • Additional Font Trays also available for only $10.95. Contact us.

 

    Definition of terms:
Blank: this is the size of the material that the letter is engraved on, it will fit into your copy slide groove and will be either 1 1/4" or 2 3/4" in height.

Letter Height: this is the height of the largest upper case character measured from the center of the top groove to the center of the bottom groove of the letter.


 

 

 

Times Roman IV

 

/i/Font Images/cirblk2.gif

/i//plastic_trays.gif

Each set contains a MINIMUM of the following characters.
Most sets contain even more!

  AAA BBB CCC DDD EEE FFF GGG HHH III JJJ KKK LLL MMM NNN OOO PPP QQQ RRR SSS TTT UUU VVV WWW XXX YYY ZZZ 111 222 333 444 555 666 777 888 999 000
! @ # $ % & * ( ) + = : ; " ' , . ? / \

 Packaged in a storage tray with lid. Complete satisfaction warranty. Custom orders our specialty.  Made in America.

 The font storage tray / lid shown here can be purchased separately.
They're great for old loose fonts or small parts that are hard to keep organized around your shop.
You can purchase these for $10.95 each, add $5.50 shipping and handling.


 Are you wondering just how well this high tech composite material will stand up?
This letter "V" font pictured here has been traced 1,100 times and shows just how tough this stuff is!

As you can plainly tell from this photo, there is only the slightest of wear. This font is ready and able to handle the rigors of even the the most demanding shops! There's allot of miles left in this font and all our products are made from this same composite material. In fact, the more you use this material it actually becomes easier to trace! This material over time will become very smooth and you can feel the difference as you trace with your stylus.

As good as the old brass? We think it's better and we're betting you will too! Why not give it a try?


 

 

/i/Font Images/VFONT2.jpg